Radijator Inženjering d.o.o, 36000 Kraljevo, Živojina Lazića - Solunca br.6, Srbija
tel. +381 36 399 140, fax. +381 36 399 150, http://www.radijator.rs
e-mail: [email protected]
59
2. Description of the boiler
Boiler
Ecoflame Plus 25/30
was developed with the aim for Radijator Inženjering to offer to the
market a boiler which, as per its mechanical and thermal properties, is intended for use of pellets
as fuel.
If the user wishes to use some form of biomass that is not listed, he/she should contact the
Construction and Development Department of Radijator Inženjering or the authorized
dealer, since some forms of biomass often require specific combustion solutions.
Using the
stated fuels implies automatic control of the main work parameters. In all stated examples of use
of biomass, a certain fuel dryness level is required. On the other hand, market demands are such
that they always seek more universal fuels.
Wood pellets are produced from 100% cellulose. Wood residues are compressed under high
pressure into pellets of 6mm in diameter and 2-3cm in length. Pellets should be appropriately
stored in a dry place in order to ensure efficient combustion. Boiler
Ecoflame Plus 25/30
uses
pellets of 6mm in diameter, 5-30mm in length and moisture up to 10%, produced as per the
EN
14962-2
standard. If the pellets are not produced as per the stated standard or its quality has
deteriorated during the storing or transport, Radijator Inženjering, as the manufacturer, cannot
have liability for the poor work of the boiler. In such situations, there might be errors in ignition,
pellets might be piling up and falling out of the place for combustion, there might be insufficient
power, etc.
Ecoflame Plus
is installed in the boiler room or other rooms, and it has an advantage in situations
where more compact dimensions are required.
It is assembled on a classic chimney of minimum 130mm in diameter. The chimney must meet all
other standards as classic boilers. More on this may be found in the Assembly section.
An adequate circulation pump has been installed in the boiler. The boiler is delivered with the
safety valve and air vent. In addition to
Ecoflame Plus,
there is also a model
Ecoflame
which
does not contain circulation pump, safety valve, filling and drainage tap.
Adequate circular pump is installed within the boiler. The boiler is delivered with the safety and
air vent.
Pellet combustion is done as per the principle of volcanic fuel supply.
The entire process is run by the automation system which allows the selection of one of two
levels of power (25/30kW).
It is possible to connect the room thermostat and set the periods of start of work and standby
phases for 7 days.
