Radicon J 100, Manual

Page: 69 / 76

65
SERIES J
Mounting of backstop
When using backstops in shaftmounted speed reducers
you have to consider among other things the limit of speed
and torque according to the following table.
Fig 2
ASSEMBLY
OF BACKSTOPS
Fig 1
Size
Backstop
Type
Max input
torque
Nm
Input speed
r/min
Min Max
Tightening torque
(29:3)
J12 J22 J32
Nm 17 35 41
J 12 ASNU15EP 75 - 2400
J 22 ASNU17EP 112 - 2300
J 32 ASNU20EP 160 - 2100
J 52 ASNU30EP 500 - 1400
J 72 ASNU30EP 750 - 1200
J 100 RSCI40 1600 720 7600
J 110 RSCI45 1800 665 6600
J 125 RSCI50 2800 610 6100
J 140 RSCI60 4700 490 6100
J 160 RSCI70 6100 480 4500
J 190 RSCI80 9000 450 4000
Max input torque at the backstop is valid at 4,5 x 10 5 load
changes and must never be exceeded.
Direction of rotation for back stop is valid for double reduc-
tion gears. Look at reducer from input shaft side and
deter-
mine direction of rotation of output shaft sleeve, counter-
clockwise (BV) or clockwise (BH). See Fig 1.
Please state required direction of rotation when ordering
back stop reducer.
Instruction for backstop J12 - 32.
Assembly see fig 2
Operation temperature -30 °C to +100 °C.
I. Take out cover (14*) from standard reducer.
2. Fit the key (29:6) into the keyway between shaft (1*) and
back stop (29:7).
3. Mount the circlip into groove (29:5).
4. Determine direction of rotation for the back stop (29:7), fit
the back stop unit (29:6) into reducer housing push it
into close contact with the spacer ring (Direction of
rotation is changed if back stop is reversed).
5. Push the backstop bracket (29:2) into the reducer
housing and ensure that the two lugs locate with the
groove on the back stop.
6. Rub the mechanical joint discs (29:1) with oil.
NOTE: OIL MUST NOT CONTAIN MOLYBDENUM-
DIFULSIDE
7. Fit the mechanical joint discs (29:1) into backstop
bracket (29:2).
8. Apply sealing compound on thread under screw head
(29:3) 5 mm width.
9. Fit the cover (29:4) with screws enough to adjust cover.
Tighten screws alternating until the required tightening
torque is reached.
Dismount see fig 2
1. Dismount the screws (29:3).
2. Dismount the cover (29:4).
3. Dismount the mechanical joint unit by using the
three
screws (29:3) and tighten the screws against the
shaft end / backstop with equal load.
4. Dismount the circlip (29:5).
5. Pull out the backstop (29:7).
Do not clean before assembly.
*Acc to spare parts list.
0202
- - NO BACKSTOP
B V COUNTER CLOCKWISE ROTATION
B H CLOCKWISE ROTATION
Column 15 & 16 entries
Picture shows counter clockwise rotation (BV)
Output
shaft
Input
shaft