6
3.
HEATER
: press the heater button, the product starts working at low power(1200W). Air speed is automatically
set to MEDIUM level. Press again the heater key to increase power to high level(2000W). to switch off the
heater
mode
, there are two way. 1: press the SPEED button, the
heater mode
switch off and the fan works in
HIGH speed. 2: press the ON/OFF button, the fan heater goes on working in
ventilation mode
for 10 seconds
and then switch off completely.
4.
ECO
: press this button when the appliance is in heater mode to set the comfort level.
You can choose among 3 different comfort level set: 22°C, 28°C and continuous heating. Depending on the set
comfort level the corresponding led lights on. If the temperature has been set to 22°C or to 28°C the product
works until the ambient temperature reach the set level. Then the
heater mode
will be switched off and only
ventilation mode
will be in function. When the ambient temperature will fall 2°C below the set value, heating will
be automatically resumed.
5.
TIMER
: Press this button to set the timer among 1h>2h>4h>8h>off>1h. After setting the time, the unit
immediately enters countdown state, the timer led indicates the remaining value of countdown(for example: if
the timer is set to 8h and it has gone to 4h, the unit shows the 4h indicator). The unit turns off and enters standby
state after countdown.
6.
COOLER/HUMIDIFIER
: Press the air cooler button. In this mode, it is necessary that the water tank is full with
water. Water will be sucked by the pump and poured in the evaporative filter. Passing through the filter air gets
wet and fresher(2 to 3°C colder than air temperature). Water shortage protection switch is integrated: When the
humidifier function is turned on and the water level is below the minimum level the system will turn off the pump;
the buzzer makes
a double “beep” sound and alarms for 5 seconds, the humidifier function turns off and reminds
the user to add water. Water level can be easily checked through the transparent indicator on the front of the
water tank. We recommend to use this function during the cooling season for a more intense and fresh effect but
also during the cold season to make the hot air less dry.
7.
SWING
: Press this button once to active the rotation function.
When the oscillation function is turned on the unit
swings on a 90° angle for a wider ventilation effect.
Press again the SWING button to deactivate the function. The corresponding led turns on and off accordingly.
Refilling water
Do refill water before use Cooler/Humidifier. Pay attention to the water level when refilling water .
1.
Remove the water tank door.
2.
Keep water not lower than Min. level and not higher than Max. level.
3.
Put the water tank door back after refilling water.
4.
Use clean water.
5.
After refilling the water, push back into the drawer and lock the water tank.
6.
Kindly Reminder
：
For the first usage, possibly there would be some scent and discoloring in the water. NO harm
to health at al
Note: the water tank cannot be removed.
