6
5. User maintenance
EMPTYING THE TANK
The process of dehumidifying the air produces water, which is collected in the tank. The water can be
allowed to drain directly to outside the product.
COLLECTING WATER IN THE TANK
If the tank gets full of water, the compressor will stop and the
TANK FULL LED will switch on. If this occurs:
-
Switch the product off and disconnect the plug;
-
Remove the water tank as shown in the picture;
-
Empty the water;
-
Put the tank back in position;
-
Start the product again, setting the humidity required again.
DARINING THE WATER TO OUTSIDE
Before starting the product, remove the tank and connect a
PVC hose to the humidity drain hole. Put the tank back in
position.
PLEASE NOTE! The end of the drain hose must be lower than
the drainage hole.
REMOVING AND CLEANING THE AIR FILTER
We recommend doing this task at least once every 3 weeks.
Remove the water tank after switching off the product and
disconnecting the plug.
Extract the filter by pulling it downwards, after having gripped it
by the handle.
Wash the filter with luke warm water only, and dry it completely
with a cloth, then leave it in the air to eliminate any remaining
wetness.
Put the filter and the water tank back in position.
HOW TO MAKE THE BEST USE OF AND CARE FOR THE PRODUCT
This product must always work in a horizontal position, on a solid, flat surface.
Do not insert any object in the air intake or air outlet vents.
When you do not intend to use the product for a long period of time, disconnect the plug from the socket,
wind up the cable and put the product in a protected, dry place, at a temperature that is never too cold or
too hot.
