User manual
B-RAD X
V1.0 - May 2023
25
5.1.2 Faults
When you see a fault, it is followed by a number. This indicates a hardware anomaly has occurred and the
tool needs to be sent to the nearest repair facility for repairs. Contact Radial Torque Tools B.V. or a RAD
distributor, report the fault code and describe the conditions before the fault occurred to determine if the
tool needs to be sent for repair.
Report the following information/conditions prior to a fault:
• Tool model, serial number, software versions.
• Torque setting of the tool.
• Battery state of charge.
• Number of torque cycles in a row and length of each torque cycle.
Fault Display
Fault Meaning
FLT1
Idle Over Current.
FLT2
Encoder Fault.
FLT3
Driver Fault.
FLT4
No Current Fault into Motor.
FLT5
UI Board Fault – Invalid Board Detected.
FLT6
Quad Encoder Fault.
FLT7
Motor Stall Fault.
FLT8
Board Temp Sensor Fault.
FLT9
Motor Temp Sensor Fault.
FLT10
Voltage detection Fault.
FLT11
Bridge Comms Fault.
FLT12
Current Sensing Fault.
FLT13
MCU Init Fault.
FLT17
UI Board Comms Fault.
FLT18
MCU/UI Synchronization Fault
FLT19
MOSFET Failure Fault
Table 6.1-2: Faults List
6. Contact
Radial Torque Tools B.V.
Zuidergracht 19
3763 LS Soest
The Netherlands
Phone: +31(0) 35-5882450
Mail: [email protected]
Website: www.radialtorque.eu
