49
Preparatory work when using precision tubes (Figures
-
)
1.
Measure the distance between the adapter and the rear third of the
driver and mark this distance on the precision tube.
RolloTube Comfort Small
RolloTube Comfort Medium
1
1
2.
Saw a notch
1
at the end of the precision tube so that the raised part
of the adapter can be pushed fully into the tube.
NOTE
◆
There must be no play between the notch
1
and the raised part
.
◆
The dimensions of the notch
1
depend on the type of tubular motor, see figures.
5.a
5.b
5.c
Pushing the tubular motor into the winding shaft (Figure
)
1.
STOP
Do not push the motor (9) into the
winding shaft (5) using force.
This could destroy the motor.
First, push the driver (8) into the winding shaft (5)
IMPORTANT
When installing winding shafts such that the rabbet is on the inside, it must be
ensured that the motor
(9)
has sufficient free space.
2.
Then push the winding shaft (5) onto the adapter (10).
IMPORTANT
Make sure that the adapter
(10)
does not slide off the limit ring
(18)
on the motor
head
(12)
during assembly as this can cause malfunction, see page 56.
EN
