RADEMACHER RolloPort S2, Translation Of The Original Operating And Assembly Manual

Page: 29 / 36

i
Connecting additional electrical equipment
When working on electrical systems there is
a risk of danger to life due to electrocution.
◆
The connection of additional electrical equipment
must only be carried out by a qualified electrician.
◆
Before opening the protective cover always dis-
connect the equipment from the mains power supply
and check that the system is free of voltage.
Accessories from other manufacturers may
result in malfunctions or damage to property.
◆
Use only original accessories. A separate source
voltage at the screw-type terminal for the external
switch will result in a short circuit and will destroy
the door operator’s electronics.
If the external buttons are not connected
properly, the operational safety of the
equipment is at risk.
Always mount the internal button, programming
button, etc.:
◆
outside the reach of movable parts
◆
within visibility of the door
◆
at a height of at least 1.5 metres
If a wicket door is installed, the door position
must be monitored. It must be ensured that
the drive is not active if the door is not closed.
Key
(1)
= main board
(2)
= infrared light barrier (optional)
(3) = pass door contact
(4) = external switch (optional)
(5)
= Signal lamp (24 V)
* The signal lamp flashes as long as the
drive moves. It is not a permanent light.
NOTE!
Remove the respective factory installed bridge before
connecting a light barrier or a pass door contact.
24
V
GN
DI
R1
IR
2
GN
D
VC
C
TX
GN
D
VC
C
TX
VC
C
GN
D
CO
M
IR
RX
VC
C
GN
D
CO
M
IR
RX
ANT
EMRG
GN
DD
OOR
+ LAM
P
-
24 V
( 1 )
( 2 )
( 4 )
( 3 )
( 5 )
RolloPort S2
29
EN