10
i
Important advice before adjusting the settings
Settings
Initial operation
1
3
2
4
Two situations can be distinguished in which you adjust settings:
◆
Initial operation/installation of a Fernotron system for the
first time.
◆
Subsequent changes/settings made to an existing Fernotron
system.
Please proceed as follows:
Preliminary thoughts:
Fill in the table on page 14 with the allocation of the receivers
(including the names and number) and the desired settings.
ADVICE
Please refer to page 13 for a table of the names
suggested and preset by the manufacturer.
Call up and carry out the commissioning assistant (see page 17)
Basic settings via menu navigation with standard switching times
including allocation of the names and numbers of the groups
and receivers.
ADVICE
This will make you familiar with the setting principle.
Other settings enabling individual adaptation
◆
Setting the weekly timer
◆
Activating and setting the automatic sunlight protection mode
etc.
Registration of the Programming Centre and data transmission
◆
To enable your settings or manual switching commands
to become active you must first register the Programming
Centre once with each Fernotron receiver (see page 40).
The allocation and all settings (including the time etc.) will
also be transmitted to each individual receiver at the same
time.
