7 of 15
Radar Speed Sign Operation Manual_MN0036 v23.01
Basic Sign Setup
To set up your sign for the first time, you do not need
to leave this
HOME
page.
The
Sign Status
box at the top of the page
displays the following:
•
Battery voltage
: If battery charge is 13.9+ V, bat-
tery is charged 100%. If voltage is less
than 10V, the display will shut off to allow the bat-
teries a chance to recharge)
•
Solar amperage
: If you have a solar sign the
“
A
”
(amperage) will be low if the battery is fully
charged. Batteries need to be recharged if
solar amperage level is between 1 to 3 Amps.
•
Date and Time: date and time the program is
accessed
Action Buttons
A)
Get Radar Data
–
Used to download data from
the radar speed sign. (
If you have not
purchased a Streetsmart license for this sign, this
option does not apply.)
B)
Refresh
-
Reloads the sign settings on the page.
C)
Change Password
-
Allows you to re
-
set the Wi
-
Fi password to something other than the default. If you change
the default password, make sure you record it. Radarsign will not have a record of changed passwords. If lost you will
need to reset to factory settings to create a new password.
General Settings
1)
Blinky Enabled
–
Turns the single blue LED in the center of the display on or off. This Blue LED indicates that
the radar is scanning. It is recommended you keep it enabled.
2)
Radar Enabled
–
This should
always
be checked so the sign can detect vehicles.
3)
MPH / KPH settings
–
Select the setting for your country
’
s standard
Display Configuration
4)
Display Enabled
–
Turns the display on or off.
UNCHECK
if you wish to collect traffic statistics in stealth mode
to get a baseline of how fast the speeds are on the road in question.
5)
Speed Limit
–
Enter the speed limit of the road where the sign is installed. The speed limit is only used to qualify
a speeder vs. a non
-
speeder and has no effect on the display.
PLEASE NOTE: It is very important to consider the traffic speeds at the sign location when configuring
the Minimum and Maximum display speeds settings in order to conserve the sign battery charge level
and maximize the battery life
.
6)
Minimum Display Speed
–
Set the speed to the lowest level you would like the radar sign display to activate. If
approaching traffic is below the minimum speed setting the display will be blank.
Guidance: Most customers
select a speed matching or a few miles per hour below the posted speed limit.
Setting this number too
low will simply waste battery energy and reduce the battery charge level
.
7)
Maximum Display Speed
–
Set for the highest speed you wish the sign display to remain active, usually no
more than 20 mph higher than the speed limit. This is used to ensure drivers do not try to
‘
race
’
up the sign to
unsafe speeds. Above this speed the Over Max Speed behavior is active.
8)
Over Max Behavior
–
Indicates the sign alert display when a vehicle is travelling faster than the max speed
selection. Choose either
Dashes
, or
Blank
(sign goes dark).
A
B
C
1
2
3
4
5
6
7
8
