W W W . R A D P O W E R B I K E S . C O M
4
Assembly Instructions for The RadRover
Follow these assembly instructions if you would like to install the Front Rack on the 2018 RadRover. If you are installing the
Front Rack on a different 2018 Rad Power Bike model, please go back to the table of contents and look for the appropriate
page.
NOTICE:
The following assembly steps are only a general guide to assist in the assembly of your Front Rack and is not a complete or comprehensive
manual of all aspects of assembly, maintenance and repair. We recommend you consult a bicycle repair specialist to assist in the assembly, repair and
maintenance of your bicycle and all accessories.
Required Tools:
-
2mm, 3mm, and 4mm Allen Wrenches
-
Philips head screw driver
-
8mm and10mm wrench
Step 1:
Check how the brake cable is routed on your bike. If it is
routed behind the fork brace like the picture below,
then skip to
step 3
. If the cable is routed in front of the fork brace, then move
on to step 2 where steps to move the brake cable to the rear of
your fork will be outlined.
The cable should be routed on rear of fork as shown. If routed on
rear of fork as shown above, skip to step 3.
