STEP 3: SQUARE POT RACK ON TABLE
Place assembled rack squarely on table and adjust all parts to be certain they are level and straight. Then tighten all bolts
firmly.
Now measure the distance between holes center to center at tops of brackets and note for later use when you install (see instal-
lation instructions below).
STEP 4: POSITION WOOD SHELF
Note the small holes located in the center of the flat section of each bracket. Two set screws (18E) will be driven through them
to secure the Wood shelf to the brackets.
Center the Wood shelf on top of the brackets (now fixed in position) then with a pencil mark the two set screw points on the un-
der side of the bracket. Pre-drill the marks with a 1/8
"
drill bit (or tap a starter hole with a hammer and a small nail) then drive
set screws (18E) into Wood to secure shelf.
You’re now finished and ready to attach to the wall!
TOOLS NEEDED FOR INSTALLATION:
Provided: Installation hardware (anchors, bolts, and wall screws)
You will need: level, tape measure, pencil, electric drill, ½
"
drill bit, hammer and nail.
STEP 1: LOCATION
Decide where you want to place your pot rack. Consider the height of the wall where the pot rack will hang, keep-
ing in mind how far below the rack your pots and utensils will hang.
On the wall, mark the two points where you would like to hang the rack, then tap a small nail through each mark to
be certain a joist is not in the way. NOTE: because your pot rack includes toggle anchors, you DO NOT need to
locate and bolt to studs. See more information under STEP 2 below.
STEP 2: INSTALL TOGGLER® DRYWALL ANCHORS
The included drywall Toggles eliminate the need to bolt your pot rack to a stud. The steel anchors are very strong
and when installed in drywall each drywall anchor holds about 100 lbs. Two anchors hold about 200 lbs. Install the
two Toggle drywall anchors (27A) where the two holes in the tops of the two bookshelf arms are located. Carefully
follow Steps 1 through 4 of the Toggle Drywall Anchor instructions found on the back of this booklet.
INSTALL IN WOOD?
If you need to install one or both sides of your rack in wood, use as many of the two wall screws (18E) included to
meet your needs.
How to Attach Your Pot Rack to the Wall
