TIP! SAVE TIME AND HASSLE. PLEASE READ ENTIRE INSTRUCTIONS BEFORE BEGINNING ASSEMBLY.
PAINTABLE -
Want a different color? The finish on this pot rack can be spray painted any color. We
recommend Rustoleum “Hammered” colors for their metal-like finishes, however any quality spray-can paint may be
used. See a paint retailer for guidance.
WOOD SHELF
is coated with wood oil to enhance the grain and minimize warping due to humidity fluctuations. We
recommend that it remain “natural.”
TOOLS NEEDED -
Hex wrench, fastener hardware (nuts, bolts) are provided
.
STEP 1: LAYOUT PARTS
On a table lay out all parts as shown in the exploded view above.
STEP 2: LOCATE BRACKET ON BAR & SECURE
Note the small hole near the end of the side bar (3C) Place a bracket (12) over the hole to cover it, then slide the brack-
et back and forth (an inch or so either direction, keeping the hole covered) until you have determined for yourself the
most pleasing distance from the end of the bar. Mark that distance, then with button head bolts (18A) secure the other
bracket at the same point from its end.
How To Assemble Your Pot Rack
TIP!
FIRST, CLEAR PAINT FROM SCREW HOLES. Because the powder coat finish applied at the
factory also adheres to the inside of screw holes, turning a screw through it during assembly may be difficult.
Therefore, before connecting parts, we recommend that you clean out screw holes in brackets (12). Using a
button head screw and hex wrench provided, rotate the bolt through each screw hole, then withdraw it. That
will push paint out and make securing parts easier.
Item No.
Description
Qty.
Item No
Description (Hardware bag contents)
Qty.
3C
Wall/Ceiling bar
1
18A
Button head screw - 1/4”
2
12
Wall bracket
2
19C
Button head bolt - 2”
2
29
Wood 22” x 3.5”
1
18E
1/2” wood screw #8
2
25A
Pot hook straight
4
26A
Hex wrench
1
25B
Pot hook angled
4
30A
Wall Screw
2
27A
Toggle
2
MISSING A PART?
Please call our TOLL
FREE SERVICE CENTER
1 (877) 362-5863
