10
CUTTING WITH A NYLON HEAD
For nearly all cutting, it is good to tilt the line
head
so that contact is made on the part of the line
circle where the line is moving A W A Y from
you and the debris shield. (See appropriate) This
results in the debris being thrown A W AY from
you.
WARNIN
△
,!
DANCER
The proper debris shield must be in place on the
unit when nylon cutting line is used, The cutting
line can flap around if too much line is exposed.
Always use the plastic debris shield with cut-off
knife when using nylon cutting heads.
WARNING
△
,!
DANGER
Tilting the head to the wrong side will shoot the debris
TOWARDS you. If the line head is held flat to the
ground so that cutting occurs on the whole line circle,
debris will be THROWN at you, drag will slow the
engine down, and you will use up a lot of line.
WARNING
△
,!
DANGER
Use only quality nylon monofilament line of the
diameter 2.5mm, Never use wire or wire-reinforced
line in place of nylon trimmer line. Load your nylon
line cutting head only with nylon trimmer line of the
proper diameter.
WARNING
△
,!
DANGER
Use extreme caution when operating over bare spots
and gravel, because the line can throw small rock
particles at high speeds. Debris shields on the unit
cannot stop objects which bounce or ricochet off hard
surfaces.
