Racing RAC1036ET, User Manual

Page: 16 / 24

At the end of the season, or if the tiller is not being used for longer than a month, wipe over all
metal surfaces with an oil impregnated cloth to protect them from corrosion or spray with a fine
coat of oil. Fold the guide bar down, and store the tiller in a suitable place.
7. TROUBLESHOOTING
Problem Possible causes Remedy
Motor does
not start
Unit not plugged in Plug in the unit
No electricity Check power supply
Defective cable Check cable. Repair or replace if required
Defective safety
switch/plug
Arrange for repair
Overheat protection
activated
1.Working depth too large, set to a shorter depth.
2.Blades blocked, remove the blockage.
3.Soil too hard, select correct work depth and move
forward and backward several times while slowing
down the operation speed.
Wait until the motor cools down for about 15 minutes
before further use.
Abnormal
noises
Blade is jammed Switch off. Wait till tines come to a complete stop.
Remove jammed objects.
Lubrication running
out
Tiller must be repaired. Call our customer service help
line.
Bolts, nuts or other
components are
loose.
Tighten all components. Arrange for repair if noises
continue.
Abnormal
vibrations
Blades damaged or
worn
Replace damaged or worn blades.
Working depth too
large
Set to correct working depth.
Poor results Working depth too
small
Set to correct working depth.
Worn blades Replace damaged or worn blades.
8. DISPOSAL
Electrical products should not be discarded with household products. According to the European
Directive 2012/19/UE on waste electrical and electronic equipment and its implementation into
national law, electrical products used must be collected separately and disposed of at collection
points provided for this purpose. Talk with your local authorities or dealer for advice on recycling.