17
3. ASSEMBLY
Assembling the flexible tube with the engine and the pipe support
-
Pull the key which is on the clutch housing. Insert end of the flexible tube (with the hole) into the clutch
housing on the engine until it locks in place. Release the key.
-
Insert the other end of the flexible tube into tube until it locks into place.
-
Make sure that the end of the flexible shaft is properly seated in the drive shaft seal.
CAUTION: If the flexible tube is not inserted properly, the square end of the hose may not fit snugly
in the drive shaft seal. Do not use force to avoid damage to the flexible shaft. Repeat the same
procedure until the flexible shft and hose are adjusted.
Connecting the command cord
-
Connect the command cords to the two engine leads by inserting them into each other.
Mounting the throttle cable
-
Remove the air filter cover.
-
Place the throttle cable in the adjusting bolt. Be careful that the round hole of the rotating joint faces the
end of the inner wire.
-
Leave the rotating seal and make sure that the inside wire is properly seated in the hole.
-
Reinstall the cover of the air filter.
