Racer INVERTER 11, Manual

Page: 67 / 108

- 64 -
6.2 Electrical protection
The power supply for the heat pump must come, preferably, from an exclusive circuit with regulatory
protection components (30mA differential protection) and a magneto-thermal switch.
- The electrical installation must be carried out by a specialized professional (electrician) in accordance
with the standards and regulations in force in the country of installation.
- The heat pump circuit must be connected to a safety earth circuit at the terminal block.
- The cables must be properly installed to prevent interference.
- The pump is intended for connection to a general power supply with earth connection.
- Section of the cable; This section is indicative and should be checked and adapted according to the
needs and conditions of use.
- The tolerance of acceptable voltage variation is +/- 10% during operation.
The connections must be dimensioned according to the power of the device and the state of
installation.
Models
Circuit
breaker
Maximum length of the wire
2,5 mm² 4 mm² 6 mm² 10 mm²
RACER INVERTER 7 9 A 80m 128m 192m 320m
RACER INVERTER 9 11A 65m 104m 156m 260m
RACER INVERTER 11 13 A 43m 68m 100m 170m
RACER INVERTER 14 17 A 35m 56m 84m 140m
RACER INVERTER 16 18 A 30m 48m 72m 120m
RACER INVERTER 19 23 A / 25m 38m 62m
RACER INVERTER 25 28 A / 22m 35m 55m
These values are given as a guideline, only the intervention of an authorized technician
can determine the values corresponding to your installation.
The electric line must be equipped with a ground connection and with a circuit breaker with
difference 30mA in head.
6.3 Installation of the display deportee
Photo(1) Photo(2) Photo(3) Photo(4) Photo(5)
- The side with plug connects with the control panel (photo1)
- The other side of the signal wire. (photo2)
- Open the wiring panel and put the side without plug through the electrical box. (photo3,4)