Racal Instruments 7064R-S-1844, Instruction Manual

Page: 13 / 48

Instruction Manual 7064R-S-1844
Installation Instructions 2-1
Chapter 2
INSTALLATION INSTRUCTIONS
Introduction
This section describes the unpacking, inspection, set-up and
installation of the Model 7064R-S-1844 Register Based module in a
C-size mainframe.
Unpacking and
Inspection
1. Before unpacking the 7064R-S-1844 module, check the exterior
of the shipping carton for any damage. If the shipping carton is
damaged, inform the carrier immediately.
2. Remove the 7064R-S-1844 module and inspect it for damage. If
any damage is apparent, inform the carrier immediately. Retain
shipping carton and packing material for the carrier’s inspection.
3. Verify that the pieces in the package you received contain the
correct 7064R-S-1844 module option and the 7064R-S-1844 Users
Manual. Notify Racal Instruments if the module appears damaged
in any way. Do not attempt to install a damaged module into a VXI
chassis.
4. The 7064R-S-1844 module is shipped in an anti-static bag to
prevent electrostatic damage to the module. Do not remove the
module from the anti-static bag unless it is in a static-controlled
area.
Address Switch
Settings for
Configuration
Control
The 7064R-S-1844 Register Based Module has an internal 8-
position address dip switch, S1, used to determine the static
configuration. It is located on the top of the module, accessible
through the case.
In the ON position, the switch is set to logical 1, and in the OFF
position to a logical 0.
The user can select any logical address from 1 to 254 for static
configuration.