1260-12 User Manual
Module Specific Syntax 3-2
EADS North America Defense
Test and Services, Inc.
©
1993
Figure 3-1, Relay Diagram
PSETUP
Command
The PSETUP command causes the specified module setup to be
displayed as a response. The syntax used is:
PSETUP <module address>[;<module address>]
[;<module
address>]
where <module address> is the switch card address.
The responses to the PSETUP command for the 1260-12 Relay
Actuator Module are as follows:
<module address>.1260-12 RELAY ACTUATOR MODULE
<module
address>.BBM
<module
address>.END
The response to the PSETUP command consists of a header on
the first line. The header describes the model number. The next
line designates the setup mode for the scanning which, by
default, is Break-Before-Make (BBM). The last line containing
the “END” characters denotes no more information to report.
PDATAOUT
Command
The PDATAOUT command causes the specified module to
transmit the state of the CLOSED relays (within the switching
module) to the 1260 Controller. The syntax used is:
PDATAOUT <module address>[;<module address>]
[;<module
address>]
The responses to the PDATAOUT command are as follows:
<module address>.1260-12 RELAY ACTUATOR MODULE
