background image

Operating the warning light

The warning light has 2 different operating modes, continuously on or flashing. To keep the light 

continuously on slide the warning light switch to the ON position. Slide this switch to the BLINK 

position to use the flashing mode. Slide this switch to the OFF position to turn the warning light off.

Two coloured lenses are supplied with the unit. To change the lens rotate the outer ring of the 

warning light counter-clockwise. Remove the lens that is already in place and replace it with the 

desired colour lens. Replace the outer ring.

Using the Spotlight

This product features a 3 million candlepower spotlight. To use this light, simply press the 

compressor/spotlight switch to the SPOTLIGHT position. Press this switch to the OFF position to 

turn the spotlight off.

Spotlight bulb replacement

The spotlight uses as 35 Watt Blue H3  Halogen Bulb. 

To change this bulb, first remove the housing ring by 

twisting it counter-clockwise. 

Remove the reflector and turn it over.

Remove the pin that secures the light bulb housing by 

pinching the two ends of the pin together and pulling (Fig 

1). Use a screwdriver to loosen the screw that secures the 

light bulb housing inside the reflector (Fig 2).

Disconnect the bulb connector from the wire (Fig 3). 

Replace this bulb with a new one of the same type and 

wattage. Take care not to touch the light bulb with your 

bare hands. 

The oil from your hands can shorten the life of the bulb.

Reverse the above steps to re-assemble the spotlight.

Warning light bulb replacement

The warning light uses a 12 Volt, 5 Watt light bulb. To 

change this bulb, simply remove the outer ring as if you 

were changing the coloured lens. Remove the old bulb and 

replace it with a new one of the same type. Be careful to 

not touch the bulb with your bare fingers. The oil from your 

hands can shorten the life of the bulb.

12 Volt output socket

The 12 volt output socket can power most of your 12 volt 

accessories. Simply plug the 12 volt power cord of your 12 volt appliance into the 12 volt output 

socket

-4-

All manuals and user guides at all-guides.com

Summary of Contents for HP124








Reviews: