Set-up
Check both parts of the coupling for compatibility
(cat.: tractor/ implement).
Set the lower links of the tractor to the same height.
Couple the lower link shaft.
Set the upper control arm to a height that allows it
to reach the implement when in operation.
Correctly secure the coupling assembly (three-point
linkage).
Couple the hydraulic hoses: twin-acting – 2
connections – and ensure they are properly
connected.
Function:
”Lift”
- Fold in
”Depress/Lower - Fold out
Raise the support legs
Check that there is no clashing when the
implement is folded in/folded out, e.g. with a
hinged rear window
Transportation position
To fold in or fold out, lift the implement slightly.
If a
4.5 m
long implement is being used, do not fold
in when the harrow leafs are set very low unless the
two outer sections have already been adjusted to a
”flatter” position – connector
4/1
(not required for tilth
harrows).
If using a
9 m
implement, turn down the locking
hooks (
5/1
) so that they lock automatically before
folding in the implement – ensure they have
engaged correctly.
Insert the track looseners at a low implement width.
Make allowances for the transportation height –
over 4 m.
Mount the lighting gear together with the warning
labels (
3/1
= Additional Equipment)
Fasten the lower link of the tractor to the side.
Secure the control units in the tractor.
See page 7 for further details of road-transport
procedures.
Converting to operating position
: Fold out the
side sections. On the ”
9 m
implement”, briefly
activate the pressure transducer to ”fold in” and
disengage the locking device (
5/1
)
3
4
5
1
1
1
1
4
