Rabe Albatros Variant, Operating Instructions Manual

Page: 17 / 36

17 05.2013
Albatros / Super-Albatros
Subject to technical modifications
1
5
2
Coupling hydraulic hoses (Colour pro-
tecting cap)
Turning – double-acting control device (red); with
„lifting“ function - hose from cylinder connection
“ P ” – marked at the cylinder. It is also possible to
connect to a single-acting control implement plus
separate back flow to the reservoir - hose from the
cylinder connection “ T ”; for this a hydraulically
operated pick-up arm and one additional
single-acting control device is necessary.
Width adjustment – double-acting control device
(green),
First body width adjustment – double-acting
control device (blue),
„HydroAvant“ – single-acting control device
(white).
Turning test
Lift the plough. Put up the support.
Set the control device to „lifting“ until the plough is
turned over and lies against the adjusting spindle
(5/2) , or is turned out again in case of a frame
pivoting device - then set the control device to
„neutral“ again.
After about 8 seconds the plough may be turned
again – set the control device to „lifting“ again.
If the control device is set temporarily to „lowering“,
you can immediately turn again. If during turning it
turns out that the plough is not lifted high
enough (despite the lower link pins attached
below), shorten the lifting rods of the three-point
linkage.
If this is not enough, attach the top link at a higher
position at the plough.
Check that the plough does not knock against
anything - even when turned -, e.g. against the
opened rear window!