Rabe Albatros Variant, Operating Instructions Manual

Page: 30 / 36

30 05.2013
Albatros / Super-Albatros
Subject to technical modifications
Maintenance
When working at the mounted implement, switch
off motor and take out ignition key!
Do not work at the lifted implement! – Support
lifted implements additionally against involuntary
lowering!
Prior to works at the hydraulic system, lower the
implement and depressurise the system!
Dispose of hydraulic oil properly.
Retighten all screws after first use (ca. 8 hours),
then check tightness regularly – use torque
wrench!
Tightening torques:
Tighten bolts at mouldboards with 80 Nm – also at
the slatted body,
lower link pins:
Albatros – 1600 Nm
Super-Albatros – 2400 Nm
Plough leg bolts: see table page 26.
When trash boards are used, take care that the
support bolts have contact (16/1) .
Lubricate all bearings with lubricating nipples
regularly with multipurpose grease on lithium basis:
e.g. at the turning, swivelling and width adjustment
ram, turning axis, adjusting spindle (28/2) , guide
bards (28/1) , spindle bearing (28/3) , frame bolt
(28/4) , console and push rod bearing ( 28/4 , 28/5 ),
swivelling limit (28/6) , bearing bolt of hydraulic
pick-up arm, disc coulters, depth wheel (combi
wheel) including holder, lubricate the bearings of
the stone protection daily if you work in stony soil
(HydroAvant). Check and readjust the wheel
bearing, disc coulter bearing and turning axis
bearing.
3
2
1
4
5
6
28