24
05.2013
Albatros / Super-Albatros
Subject to technical modifications
Standard skimmers / Skimmers
When changing the working width, the skimmer
and disc coulter are changed automatically as well.
Set the position in relation to the plough body, the
distance in front of the body and the depth.
Side position in relation to the body – with rod
projection.
Distance in front of the body – with turning the
guide plate
(15/4)
and rod projection.
Limit the depth in such a way that the cutting edge
is over its whole length working inside the soil.
Pay attention to the equal adjustment of the
leading tools!
The red marking „at tooth washers“
(15/3)
marks
the default factory setting. When attaching the
round rod skimmer, install the tooth washer
(15/1)
and pressure piece
(15/2)
(tooth washer with
numbers at the top – in working position).
Trash boards
The height of the trash boards may be adjusted via
the slots of the support. Do not adjust too low to
avoid too much slowing down of the soil flow. With
crumbling soil, the trash boards are only needed to
scrape off - and skim - the upper furrow crown; set
the working depth and ploughing speeds
appropriately.
At the front (landside) the „trash board“ needs to lie
on the mouldboard.
Set the support screws to contact
(16/1)
.
With heavy, tenacious – not crumbling – soil, use
skimmers instead of trash boards.
1
3
2
3
4
15
2
3
1
16
Summary of Contents for Albatros Vari-HydroAvant
Page 2: ......
Page 4: ...4 05 2013 Albatros Super Albatros Subject to technical modifications...
Page 35: ......
