Rabbit RabbitCore RCM4100, User Manual

Page: 41 / 112

User’s Manual 37
A program “runs” in either mode, but can only be downloaded and debugged when the
RCM4100 modules are in the Program Mode.
Refer to the
Rabbit 4000 Microprocessor User’s Manual
for more information on the pro-
gramming port.
4.3.2 Standalone Operation of the RCM4100
Once an RCM4100 series module has been programmed successfully, remove the pro-
gramming cable from the programming connector and reset the RCM4100 series module.
The module may be reset by cycling the power off/on or by pressing the
RESET
button on
the Prototyping Board. The module may now be removed from the Prototyping Board for
end-use installation.
CAUTION: Power to the Prototyping Board or other boards should be disconnected
when removing or installing your RCM4100 series module to protect against inadvert-
ent shorts across the pins or damage to the RCM4100 if the pins are not plugged in cor-
rectly. Do not reapply power until you have verified that the RCM4100 series module is
plugged in correctly.