Rabbit RabbitCore RCM4100, User Manual

Page: 27 / 112

User’s Manual 23
Follow the remaining steps carefully in Tera Term to avoid overwriting previously
saved calibration data when using same the file name.
Tera Term is now ready to log all data received on the serial port to the file you specified.
You are now ready to compile and run this sample program. A message will be displayed
in the Tera Term display window once the sample program is running.
Enter the serial number you assigned to your RabbitCore module in the Tera Term
display window, then press the
ENTER
key. The Tera Term display window will now
display the calibration data.
Now select CLOSE from within the Tera Term LOG window, which will likely be a
separate pop-up window minimized at the bottom of your PC screen. This finishes the
logging and closes the file.
Open your data file and verify that the calibration data have been written properly. A
sample is shown below.
• Baud rate 19,200 bps, 8 bits, no parity, 1 stop bit
• Enable
Local Echo
option
• Feed options — Receive = CR , Transmit = CR + LF
• Enable the File APPEND option at the bottom of the dialog box
• Select the
OPEN
option at the right-hand side of the dialog box
Serial port transmission
========================
Uploading calibration table . . .
Enter the serial number of your controller = 9MN234
SN9MN234
ADSE
0
float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,
float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,
1
float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,
float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,
|
|
ADDF
0
float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,
float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,
2
float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,
float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,float_gain,float_offset,
|
|
ADMA
3
float_gain,float_offset,
4
float_gain,float_offset,
|
|
END