INSTRUCTIONS
FIELD-ADJUSTABLE FFLED® INSTALLATION
RAB Lighting is committed to creating high-quality, aff ordable, well-designed and energy-effi cient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
SLIPFITTER MOUNTING
Set Screws
Locking
Bolt
(Suitable for FFLEDM, FFLEDL Only)
)
WARNING: RISK OF SERIOUS INJURY OR DEATH!
DO NOT MOUNT THE SLIPFITTER TO A TENON OR BRACKET
THAT IS 20 DEGREES FROM VERTICAL. MOUNTING ANY
ANGLE OTHER THAN 0-20 DEGREES INCREASES THE RISK
OF DISENGAGEMENT AND/OR FAILURE OF THE SLIPFITTER.
INSTALL THE POLE ON A SECURE BASE OR INSTALL THE
BRACKET TO A WALL FIRST, THEN PLACE LUMINAIRE
ONTO THE POLE OR BRACKET. DO NOT LIFT ASSEMBLED
LUMINAIRE OR POLE OR LUMINAIRE & BRACKET.
LUMINAIRE OR POLE/BRACKET MAY DISENGAGE.
Screws
(4)
Back Plate
Power
(W)
Selector Switch
Color Temperature
(CCT)
Selector Switch
Slipfi tter
Tenon
Fig: 3
Fig: 4
FIELD ADJUSTMENT
Follow instructions below to change the
Fixture Color Temperature
(CCT)
and/or
Power
(W)
from factory settings see Fig. 5 and Fig. 6.
Factory Settings:
FFLEDXS 9/13/18W 18W 5000K
FFLEDS 18/26/39W 39W 5000K
FFLEDM 52/80W 80W 5000K
FFLEDL 120/180/230W 230W 5000K
1.
Remove
Fixture Back Plate
by loosening
Screws
(4)
as shown in
Fig. 4.
2.
Locate the
Selector Switches
on the
Fixture Back Plate
as
shown in Fig. 5 and Fig. 6.
3.
Select
Color Temperature
(CCT)
and/or
Power
(W)
by sliding the
respective switch to the desired value.
4.
Replace
Fixture Back Plate and
secure with
Screws
(4)
.
1.
The
Slipfi tter
mounting fi ts a 2 3/8” O.D.
Tenon.
Place the
Slipfi tter
over the
Tenon
and secure the
Fixture
with the
Set Screws
on the side of the
Slipfi tter
(Fig. 3)
.
2.
Loosen the
Locking Bolt
and swivel fi xture to desired angle.
3.
Tighten the
Locking Bolt
.
Power
(w)
Selector Switch
Fig: 5
Fig: 6
