4
Kit Wiring
1. Attach the Universal Mounting
bar to the junction box with
the bar screws (provided). To
attach the STL200 kit to a surface
mount weatherproof box, you
must use the metal plate with
the attached gasket. The gasket
faces the junction box.
2. Easy wiring Tip: Use the “S”
shaped Hands-Free Hanging
Hook to hold the EZ Plate during
wiring.
Bar Screws
Universal
Mounting
Bar
Hook
Gasket
Insert close-up plugs
in unused holes
Finishing
Cap
Center
Screw
O-Ring
Gasket
CU4 EZ Plate
EZ Plate
3. Bring power leads and sensor kit
leads through holes in all gaskets
and into junction box.
4. Strip ½” of insulation from all
leads.
5. Attach ground wire(s) to junction
box grounding screw. Connect as
shown in wiring diagram (pg 5).
6. Twist on wire nuts. Secure with
electrical tape.
7. Align EZ Plate and metal
mounting plate to ensure proper
seal. Tighten EZ Plate center
screw to attach EZ Plate to box,
making sure O-Ring gasket is on
the screw. Two screws are
provided; use the one which
suits your assembly best.
8. Insert plastic Finishing Cap in
the center of the EZ Plate for a
weatherproof seal.
9. Use silicone sealant around all
openings to ensure a
weatherproof seal.
10. Screw in light bulbs and turn on
power. Conduct a Walk Test (pg
6) to adjust sensor response.