HBLED HSLED HNLED INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
®
TROUBLESHOOTING
1. Check that the line voltage at fixture is correct. Refer to
wiring section.
2. Check the fixture is grounded properly.
3. If sensor is connected, check if it is working properly.
HBLED HSLED HNLED-IN-0514
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1. Clean lens & fixture with non-abrasive cleaning solution.
2. Do not open fixture to clean the LED. Do not touch the
LED.
3. Keep leaves and debris out of hood.
Easy Installation & Product Help
Tech Help Line
Call our experts 888 RAB-1000
©2014 RAB LIGHTING Inc.
Northvale, New Jersey 07647 USA
rabweb.com
Visit our website for product info
Answered promptly [email protected]
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during
installation, operation or maintenance.
ON-OFF WIRING
Universal voltage driver permits operation at 120V thru 277V,
50 or 60 Hz. Units ordered with (/480V) suffix are 480V. For Non-
Dimming, follow the wiring directions as in fig. 1.
1.
Connect the black fixture lead to the (+) LINE supply lead.
2.
Connect the white fixture lead to the (-) COMMON supply
lead.
3.
Connect the GROUND wire from fixture to supply ground.
LIGHT
FIXTURE
(+)LINE
BLACK
(-)COMMON
WHITE
GROUND
GROUND
Fig. 1
Fig. 2
0-10V DIMMABLE WIRING
Universal voltage driver permits operation at 120V thru
277V, 50 or 60 Hz. 0-10V control wires must be rated for 300V
minimum. For 0-10V Dimming, follow the wiring directions as
in fig. 2.
1.
Connect the black fixture lead to the (+) LINE supply lead.
2.
Connect the white fixture lead to the (-) COMMON supply
lead.
3.
Connect the GROUND wire from fixture to supply ground.
Do NOT connect the GROUND of the dimming fixture to
the output.
4.
Connect the purple fixture lead to the (V+) DIM lead.
5.
Connect the gray fixture lead to the (V-) DIM lead.
6.
Cap the yellow fixture lead, if present. Do NOT connect.
Patent:
Pending: Pat. pending