BLED5 INSTALLATION INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
WARNING:
Make certain power is OFF before installing or maintaining
fixture. No user servicable parts inside.
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000, or email: [email protected]
LOCATION
1.
The Bollard should be mounted to a firm level
surface.
2.
Anchor bolts may be used in new concrete
installations. Use the template provided.
3.
For all other applications use anchors suitable for the
mounting surface.
ANCHOR BOLTS INSTALLATION
CAUTION: Install according to all applicable local codes.
1.
Install two
Anchor Bolts
in concrete foundation (by
others) using the template provided.
Mounting Plate
may also be used as the template.
Anchor Bolts
should protrude no more than 3”.
Concrete
Conduit
Anchor
Bolts
Mounting
Plate
MOUNTING PLATE
Assemble fixture(s) to bollard before mounting the Bol
-
lard to the Mounting Plate.
1.
Place the
Mounting Plate
over
Anchor Bolts.
2.
Use four
Leveling Screws
or shims to level the
Mounting Plate.
3.
Tighten assembly using the washers, lockwashers
and nuts provided.
4.
Make sure supply leads extend far enough to make
fixture connections.
5.
Slide
Gasket
down around the bottom of the
Mounting Plate
.
6.
Use the four screws to mount the
Bollard
to the
Mounting Plate. Tighten securely.
Mounting
Plate
Anchor
Bolts
Gasket
Leveling
Screws
Mounting
Screws
Bollard
BLED5 Square
BLEDR5 Round
BLED2X5 Square
BLEDR2X5 Round