Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
JBSHARK ACCESSORY INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
Easy Installation & Product Help
Tech Help Line
Call our experts 888 RAB-1000
©2015 RAB LIGHTING Inc.
Northvale, New Jersey 07647 USA
rabweb.com
Visit our website for product info
Answered promptly [email protected]
JBSHARK IN 1015
TROUBLESHOOTING
1. Check that line voltage at the fixture is correct. Be sure the fixture is grounded properly.
2. Refer to wiring, cleaning and maintenance directions on SHARK ™ (sold separately) Installation Instructions.
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation operation
or maintenance.
JBSHARK INSTALLATION
1. Secure
Bracket A (2)
to
Housing
with screws provided.
WARNING:
Brackets must be mounted at exact location
shown in
Fig. 1
.
2. Use appropriate mounting hardware (not supplied) to secure
the
Junction Box Plate (Fig. 2)
to
Mounting Surface
or
junction box
(Fig. 3)
. Check that gasket is fully sealed. Use
Cord Grip provided with fixture to feed supply wires in fixture.
3. Hang one side of
each
Bracket A
onto
Junction Box Plate
and tighten
Screws (2)
on other side as shown in
Fig. 3.
CAUTION:
•
For proper weatherproof function all gaskets must be seated properly and all screws and plugs inserted and
tightened firmly.
•
Apply weatherproof silicone sealant around the edge of the Housing. This is especially important with an uneven
ceiling surface.
•
Silicone all plugs and unused conduit entries and USE SHARK WITH CONDUIT ONLY.
•
FOLLOW ALL SHARK
™ (sold separately) INSTALLATION INSTRUCTIONS
Fig. 1
Housing
Bracket A (2)
Fig. 2
Junction Box Plate
Fig. 3
Mounting
Surface
Junction
Box Plate
Bracket A (2)
Screw (2)
