4 Installation
4.1 Hardware Installation
Figure 4I: Dimensions are in millimeters (mm)
Screw the antenna(s) to the device’s SMA connector(s).
Note: antenna is not included in
the diagram.
ATTENTION
— Antennas should only be tightened by hand or with a torque wrench of maximum 0.3 Nm.
!
4.1.1 DIN Rail Mounting
Figure 4II: DIN rail mounting
Applies to both versions of the Bridge E.
1. Use the selftapping screws provided
to attach the device to DIN rail. Place
the screws through the small DIN rail
adapter plates and screw into device
in their designated position.
2. Place the device now attached to the
adapter on the top edge of DIN rail.
3. Push the device downwards so that it
snaps into place.
TIP
— To release device from DIN rail, push the device downwards while pulling outwards.
4.1.2 Wall or Mast Mounting
TIP
— Attaching wall mounts to a device is irreversible.
1. Place the wall mounts in their desired
positions on the device. They can be
placed horizontally or vertically.
2. Use adequate force to drive the
mount bolt in the device notch.
If
using a hammer, please ensure you
do not accidentally hit and damage
the device casing.
3. Repeat with the other mounts.
Figure 4III: Wall or mast mounting
Applies to both versions of the Bridge E.
Page 7 of 45
4. Installation
