URPT/MIC & URPR/MIC
ELETTRONICA
3
/ 42
User Manual
Rev. 1.1 - 29/06/12
6.4.1 Function Menu (Fnc)
In this menu, you can toggle receiver
muting
On/Off, set
deviation display mode
and
type of transmission
(
Transm
).
To edit an item, highlight the appropriate line using the
and
buttons
and then press and hold the
ENTER
button until the command is accepted.
This way, Pwr setting is toggled between On and Off and Mod setting is toggled
between “x1” and “x10”. To edit the Power Good rate, simply select item “PgD”
or “PgR” and edit its value using the
and
buttons; finally, press
ENTER
to
confirm.
Menu 4
AF
Enables (ON) or disables (OFF) receiver muting.
Mod
Modifies modulation display (toggles between “x1” and “x10”). In “x10”
mode, instantaneous deviation indication is multiplied by a factor of 10,
and the bar meter on the default menu will reflect 7.5 kHz instead of
75 kHz. This display mode is convenient when you wish to display low
deviation levels, such as those caused by pilot tone or subcarriers.
Typ
Changes the use typology of the equipment, selectable between
transmitter (TRANSM) or repeater (REPEAT).
NOTE:
Repeat
function is used in case you want an exciter in repeater mode
together with a receiver, also if it is of other brands; if you select this mode, the
pin 15 of ACCESSORY connector should be kept to GND to enable the delivery
of output power. If you leave the pin 15 open, the output power is inhibited.
