32
/ 42
User Manual
Rev. 1.0 - 29/06/12
URPT/MIC & URPR/MIC
ELETTRONICA
WARNING: The receiver is internally protected from reversal of polarity on
the battery input through the blade fuse like car type. The latter is mounted
on the left side and accessible from outside.
6.1.3 Connections
Connect the RF input of the receiver to the antenna cable. To begin with, switch
it off.
WARNING: Electric shock hazard! Never handle the RF input connector when
the equipment is powered on and no load is connected. Injury or death may
result.
Ensure that the POWER switch on the front panel is set to “
OFF
”. The receiver
has a switch that interrupts completely the mains power of equipment.
Connect the mains power cable to the MAINS connector on the rear panel.
Note:
the mains must be equipped with adequate earth connection properly
connected to the equipment. This is a pre-requisite for ensuring operator safety
and correct operation.
Alternatively, it is possible to supply the equipment through an external battery
connected to the equipment via the ACCESSORY special connector on the rear
panel.
Finally, connect the audio output of the receiver to the devices that will use it,
depending on the configuration of your installation.
