URPT/MIC & URPR/MIC
ELETTRONICA
33
/ 42
User Manual
Rev. 1.1 - 29/06/12
6.2 First power-on and setup
Follow the instructions below in case of first power-on or after a change in the
configuration of thereceiver in which this component is integrated.
Note: Standard factory settings are AF audio off (AF OFF) and regulated mute
set to upper limit (unless otherwise specified by customer).
6.2.1 Power-on
When you have performed all of the connections described in the previous
paragraph, power on the receiver using the suitable power switch on the front
and rear panel.
6.2.2 How to enable the AF output
Check the state of the
AF
output power by the
Fnc
menu. If it is set to
OFF
, press
ENTER
to bring the selection to
ON
.
6.2.3 Level check of muting
Access the
Power Setup Menu
pressing the following keys in the order:
ESC
(opens
Default Menu
)
⇒
ENTER
(hold down for 2 seconds)
Use the keys
and
in the
MUTE
menu to set receiver muting level. When
the desired level is reached, press
ENTER
to confirm and exit to the predefined
menu.
Note: the set value is stored anyway, so if you pass the time-out without pressing
a key, the power will remain at the last set level.
