R.V.R. Elettronica TEX1000LIGHT, User Manual

Page: 23 / 40

TEX1000LIGHT
17
/ 30 User Manual
Rev. 1.1 - 06/07/20
To edit an item, highlight the appropriate line using the and buttons and
then press and hold the ENTER button until the command is accepted. This way,
Pwr setting is toggled between On and Off and Mod setting is toggled between
“x1” and “x10”. To edit the Power Good rate, simply select item “PgD” or “PgR” and
edit its value using the UP and DOWN buttons; finally, press
ENTER
to confirm.
Menu 4
Pwr
Enables (ON) or disables (OFF) exciter power output.
Mod
Modifies modulation display (toggles between “x1” and “x10”). In “x10”
mode, instantaneous deviation indication is multiplied by a factor of 10,
and the bar meter on the default menu will reflect 7.5 kHz instead of
75 kHz. This display mode is convenient when you wish to display low
deviation levels, such as those caused by pilot tone or subcarriers.
PgD
Modifies Power Good threshold for forward power. The Power Good rate
is a percent of equipment rated power (1000W for TEX1000LIGHT ),
not of forward output power. This means that this threshold set at 50%
will give 500 W regardless of set power level. The Power Good feature
enables output power control and reporting. When output power drops
below set Power Good threshold, the equipment changes the state of
pin [7] of the DB15 “Remote” connector located on the rear panel.
PgR
Modifies Power Good threshold for reflected power. The Power Good
rate is a percent of equipment rated power (100 W for TEX1000LIGHT ),
not of reflected output power. This means that this threshold set at 10%
will give 10W regardless of set power level. The Power Good feature
enables output power control and alarm management.
NOTE: This alarm does not trip any contacts in the DB15 “Remote” connector and
is only available in systems equipped with telemetry.