12
/ 32
User Manual
Rev. 1.0 - 29/11/12
TEX30/50/100/150/300LCD
ELETTRONICA
The exciter has two switches: one is embedded in VDE socket for mains power
cord and interrupts all mains power supply of the machine, while the second is on
the front panel and acts by inhibiting the switching power supply of the machine.
Connect the mains power cable to the MAINS connector on the rear panel.
Note:
the mains must be equipped with adequate earth connection properly
connected to the equipment. This is a pre-requisite for ensuring operator safety
and correct operation.
Connect the audio and RDS/SCA signals from user’s sources to the transmitter
input connectors.
5.2 First power-on and setup
Seguire le istruzioni riportate di seguito nel caso di prima accensione o dopo aver
effettuato un cambiamento alla configurazione dell’eccitatore nel quale questo
componente è integrato.
Note :
Standard factory settings are RF output power off (
Pwr OFF
) and regulated
output power set to upper limit (unless otherwise specified by customer).
5.2.1 Power-on
When you have performed all of the connections described in the previous
paragraph, power on the exciter using the suitable power switch on the front
panel.
5.2.2 Power check
Ensure that the
ON
LED turns on. Equipment name should appear briefly on the
display, followed by forward power and modulation readings. If the RF output is
disabled, those readings will be zero.
When the PLL locks to operating frequency, the LOCK LED will turn on.
5.2.3 How to enable the RF output
Check output power level and set it to maximum level (unless it has already been
set) from the Power Setup menu that you will have accessed by pressing the
following sequence of key: ESC (opens Default Menu)
⇒
ENTER (hold down for
2 seconds)
⇒
SET
⇒
use keys to set bar to upper limit (figure 5.2 - menu 2).
Check the state of the
Pwr
output power by the
Fnc
menu. If it is set to
OFF
, press
ENTER
to bring the selection to
ON
.
