R.V.R. Electronica RX1-NV LCD, User Manual

Page: 16 / 132

RX1-NV LCD
12 / 32
USER MANUAL Rev. 1.2 - 13/12/01
Note: the visualization of the following states is enabled only if the receiver is configured
for automatic alarms management
Ant “Antenna”:
Off
indicates that automatic commutation on the backup
setup (frequency and antenna) is disabled. It corresponds to the
menu item
Admin
−>
Auto
−>
Auto Off
Sig “Signal”, indicates the activation (
On
) of the automatic system
depending on the receiver signal level. It corresponds to the menu
item
Admin
−>
Alarm
−>
Signal Alm
−>
Rescue
Aud “Audio”, indicates the activation (
On
) of the automatic system
depending on the demodulated audio level in the received signal.
It corresponds to the menu item
Admin
−>
Alarm
−>
Audio Alm
−>
Rescue
Ste “Stereo”, indicates the activation (
On
) of the automatic system
depending on the pilot tone level in the received signal. It
corresponds to the menu item
Admin
−>
Alarm
−>
Stereo Alm
−>
Rescue
RDS
“RDS”, indicates the activation (
On
) of the automatic system
depending on the correctness of the received RDS frames.
It corresponds to the menu item
Admin
−>
Alarm
−>
RDS Alm
−>
Rescue
• In the right part of the default screen there is the menu item (
[Admin]
) that
permits to go on to the administration menus. This element is visible only when
one is in “input mode”, that is when the encoder is moved.
Tipically, the operations that are necessary to perform at the first start-up of the
receiver are the following:
•
(Only if automatic alarms management is enabled) - Verify in the status bar of
the default menu that the audio output “
AFO
” is set on “
Rec
” and that the
various automatic settings are all disabled (
Off
)
•
(Only if the tunable front-end is present) - With the encoder, select the antenna
input to be used. Each time you push the encoder the antenna input is switched
•
Set the working frequency:
• with the encoder select in the default menu the item “frequency”
•
push the encoder to enter in the frequency modification menu
• push the encoder on the frequency value to enter in modification mode
•
turn the encoder until the desired frequency is reached; when the set
frequency is at the center of a received radio station, the icon
is
shown.
•
push the encoder to store the new frequency
• confirm your choice pushing the encoder on “
Yes
”
• push the encoder on “
Exit
” to go back to the default screen