R.V.R. Electronica discovery, User Manual

Page: 13 / 48

DISCOVERY
9 / 44 User Manual Rev. 2.1 - 27/11/03
5. Menù
Once the Discovery is switched on, it comes visualized the loading display:
After that appear the following main display:
Press ESC to display menus. Available menus are the following ones:
5.1 Menù Detect
5.1.1 Stereo channel
The detecting method may be selected by means of the software. Stereo channels
are available in two modes: with a hardware-type contact later defined as "Switch"
and a control on the amplitude of the signal defined as "Analog".
Contacts defined as Switch are equipped with a selection inside Discovery and
set the polarity: ON when is OFF and vice-versa (see section on settings). All
contacts are enabled to ground.
To change the detection, operates as follows:
1) Position the cursor on the Detect menu and press key OK.
2) Using the arrow keys, move the menu to the channel concerned and press key
OK.
3) Using arrow keys, scroll the several configurations and press key OK.
4) Press key ESC to go back to the previous menu.
5) Repeat point 2 to change another channel.
More controls may be also enabled at the same time per each channel, obtaining
as a result that, in case of failures, the channel will be changed over with the
priority level immediately down (function Or).