39
EN
B
ollit
or
e digitale
•
Keep the power button (11) pressed for about 3 seconds, the appliance emits a beep.
If the water temperature is lower than the set one, the led indicator (14) turns on and
the appliance heats water to the desired temperature, then emits two beeps, the LED
indicator (14) turns off and temperature is maintained for 30 minutes (the corresponding
led blinks).
If the water temperature is equal or higher than the maintenance one which has been
set, the appliance emits two beeps and automatically goes into maintenance mode of
the temperature itself for 30 minutes (water cools down until reaching the set temper-
ature).
If you don’t press the power button (11) within 15 seconds from the tem-
perature setting, the appliance enters into standby mode.
•
After 30 minutes, the temperature maintenance function turns off, the appliance emits
two beeps and goes into standby mode.
•
To turn off the appliance and cancel the temperature maintenance function:
- keep the power button (11) pressed for about 3 seconds, or
- lift the kettle (1) from the stand (4), or
- disconnect the plug from the power socket.
For a correct functioning, make sure that the water quantity in
the kettle (1) is never lower than the minimum level (500ml) or
higher than the maximum one (1700ml).
If the kettle (1) is excessively filled, boiling water leakage could
occur, resulting in burn danger!!
•
Close the lid (3) by pressing it downwards until you hear it coupling.
A wrong lid (3) closing could cause overflows, steam leakag-
es and an irregular functioning of the switching-off automatic
switch.
