VL48PLB / VL48PLE
Porcelain Liner Installation
Option
NOTE: If using VLBCK48 CORNER KIT, DO NOT USE
Inner Liner Panel from Corner Kit. Remove if installed.
STEP ONE:
Remove Liner Clips and screws from inside of firebox with a
1/4” hex driver. Discard these Liner Clips but
KEEP
SCREWS.
INSTALLING VL48PLB:
STEP TWO:
Install
BACK LINER
. Attach with [Qty
2] DT Screws on bottom.
NOTE:
If you are NOT using
VL48PLE end panels, Drive [Qty 4]
DT Screws into firebox through Screw
Holes at top of Back Liner
See A at right
.
STEP THREE:
Install
BACK FILLER
on top of
BACK LINER
by inserting
TABS
into
SLOTS.
Fasten with [Qty 4] DT
Screws.
INSTALLING VL48PLE:
STEP FOUR:
Install Side Liners with [Qty 3] DT
Screws.
NOTE:
if you are using
VLBCK48
CORNER KIT,
only one End Panel
will be used.
⚠
Note: Warping and Discoloration of Porcelain or Painted Metal Liners Is Not Covered Under Warranty.
Both Porcelain and Painted Metal Liners may discolour and warp during normal operation of your appliance.
This is normal, and not considered a defect.
RIGHT
SIDE
END
PANEL
BACK LINER
BACK FILLER
LEFT
SIDE
END
PANEL
RIGHT SIDE
END PANEL
SLOTS
TABS
Also Included: [QTY 4] DT Screws
MQVLB48 WITH VLBCK48 CORNER KIT SHOWN
END CLIP
(DISCARD)
BACK CLIP
(DISCARD)
END CLIP
(DISCARD)
-VL48PLE- END PANEL KIT
Also Included: [QTY 4] DT Screws
-VL48PLB- BACK PANEL KIT
DT
Screw
DT
Screws
DT
Screws
15-3/16”
A
A
A
A
38
Summary of Contents for Kingsman Marquis MQVL48N
Page 55: ...Gas Conversion for Modulator PART C 55...
Page 67: ...Proflame 2 Remote Control 67...
Page 69: ...69...
