WARNING -
Turn off the power!
WARNING -
To avoid damage to fan
parts (especially the downrod yoke),
DO
NOT
use pneumatic or electric drivers
exceeding to 23 KGS of torque.
1.
Use the two wood screws and washers
provided to secure the hanger bracket plate
directly to the building joist via the
knockout holes from the outlet box. (Fig. 4)
NOTE:
For easy installation and to avoid
the possibility of the wood screws
breaking in half, pre-drill two 4mm
diameter holes with power tool in the
wood joist before installing the wood
screws.
CAUTION:
The hanger bracket
plate must be installed directly to
the building joist using the two
wood screws and washers provided.
2.
Secure hanger bracket to hanger
bracket plate using the two hex nuts and
washers provided, make sure nuts are
securely tighten. (Fig. 5)
CAUTION:
ALL PARTS ASSEMBLY
SHOULD BE WORKED AT THE
FLOOR.
3.
Remove the set pin and safety lock
clip from the yoke on top of the motor
assembly. Slide the downrod through the
canopy and canopy cover. Slide the yoke
cover onto the downrod (Fig. 6). Feed the
safety cable and wires from the fan motor
through the downrod assembly.
4.
(Fig. 7) Attach the downrod assembly
(downrod, yoke cover, canopy and
canopy cover) to the motor by sliding the
downrod into the yoke on top of the motor
assembly. Slide the set pin through the
hole in the yoke, downrod and secure it
with the safety lock clip. Tighten the set
screws on yoke. The yoke cover will
lower down to conceal the yoke. Feed the
safety cable and wires through the
downrod ball.
4. HANGING YOUR FAN
Fig. 6
Downrod
assembly
Ceiling
canopy
Canopy
cover
Yoke cover
Fig. 4
Fig.5
Fig. 7
Downrod
Set screw
Yoke
Safety
lock clip
Set pin
Canopy
Canopy cover
Yoke cover
Hex nuts
Metal washers
Lock washers
Safety cable
Outlet box
#14x3.5"
Wood screws
Hanger
bracket
plate
Star washers
Metal washers