39
7.5.7 Program Mode 99
With program mode 99 it is possible to disable or enable a register in the network. In order
to avoid the loss of data the registers in the network will try to sent print, balance and
article data for ever when an error occurs until you disable the register using MODE 99.
When you enable or disable a register in the network using mode 99 the register will
transmit the information to all active registers in the network when NETWORK SIZE is set
else it will only disable the register. You enter the mode by entering 99 on the TYPE key
and the register will show the status of the registers in the network. When network size is
not set the status of 24 (maximum) registers will be shown. By pressing the ENTER (CR)
key you can toggle the status of the register.
Note: When you are enabling a register take care that is enabled in all connected registers
because the register will not transmit the information to registers which are disabled.
7.6 Training Mode
Training mode allows for training on the cash register without registering what has been
rung up. No reports will be affected by whatever has been rung up in Training Mode, and
every receipt that is produced in training will be printed with a training message. A hash (#)
will also appear on the left hand side of the display.
In order to access Training Mode, a pre-programmed training clerk must be activated.
Training mode will remain activated until a new clerk is assigned. Training clerks can either
be assigned in the ( R )egister or the ( P )rogramming position. Certain clerk flags permit
the changing of training clerks in the P position only.
