0.001-6 GHz Dual Channel Upconverter
IEEE 488.2 Command Reference
6.10 *SDS
<
NRf
>
The
*SDS
(Save Default device Settings) command restores the specified state of the QM1013-102
0.001-6 GHz Dual Channel Upconverter to the default state settings. There are 5 re-writeable memory
locations, specified by choosing an index between 1 and 5. The parameters restored are the
Tune Fre-
quency, Channel 1 Attenuator 1 Setting, Channel 1 Attenuator 2 Setting, Channel 1 Attenuator 3 Setting,
Channel 2 Attenuator 1 Setting, Channel 2 Attenuator 2 Setting, and Channel 2 Attenuator 3 Setting
. For
a detailed description of the parameters saved, see the relevent command descriptions in this manual.
Issuing this command does not change the current settings. NOTE: The MEM_CLR button on the back
panel will rewrite the contents of states 1-5 with the contents of state 0 when depressed, serving as a
reset to factory defaults.
Syntax
*
SDS
Space
NRf
Allowed Values
The
NRf
parameter can be any integer in the range of 1 to 5.
Error Message
If the parameter is not in the recognized format, error
-102, "Syntax error"
occurs.
If the parameter is less than 1 or greater than 5, error
-222, "Data out of range"
occurs.
Quonset Microwave
Revision 1.2.0
71
