Section VII - Compressor Fluids
QuinSyn Flush
QuinSyn Flush is a specially formulated
synthetic fluid capable of dissolving varnish
and solubilizing sludge from lubricating
systems while they are operating.
QuinSyn Flush contains oxidation and rust
inhibitors, and can be used as a short-
term fluid (for a maximum of 500 hours).
It is fully compatible with mineral oils and
QuinSyn synthetic fluids, and is highly
recommended for use as a flushing fluid
when converting to QuinSyn PG from
QuinSyn or QuinSyn IV.
Applications
Cleaning fluid for removal of varnish, dirt
and oxidized fluid from compressor fluid
systems.
Flushing fluid when changing from other
fluids to QuinSyn fluids.
Typical Properties of QuinSyn Flush
Viscosity @ 00°F ASTM D445
43.3 cSt.
Viscosity @ 20°F ASTM D445
5.6 cSt.
Viscosity Index
65
Flash Point ASTM D92
444°F
Fire Point ASTM D92
520°F
Pour Point
–45°F
Specific Gravity 60/60
0.965
Cleaning and Flushing With QuinSyn Flush
Normal Machines
Flushing
clean
machines presently using:
A. Mineral Oils -
Drain compressor thoroughly while
hot including all the low areas. Shut
down and lockout the machine.
Detach lines and drain. Inspect
machine; if clean, change filters and
separator elements and proceed as
follows:
Fill with QuinSyn Flush and run
machine until it reaches normal
operating temperature. Drain and
refill with a fresh charge of the
QuinSyn fluid selected for your
machine. Send a fluid sample to
Quincy Compressor
®
Fluid Analysis at
200 hours.
B. Polyalklene glycols (PAG) or Silicone -
Drain compressor thoroughly as in
(A). Fill machine with QuinSyn Flush
and run for 500 hours. Send a fluid
sample to Quincy Compressor
®
Fluid Analysis. Flush may need to
be repeated several times. Analysis
will determine if further flushes are
needed.
Fill with the QuinSyn fluid selected
for your machine. Send a fluid
sample to Quincy Compressor
®
Fluid
Analysis at 200 hours.
60
Quincy Compressor-QGB
™
Back to Table of Contents