Page 4
Section 1: Safety Warning:
Section 1.1: Safety warning
This ‘EQ LTE product wide’ safety warning
should be read and understood. Additional
safety information is contained in this manual.
Both the EQ LTE product wide and additional
safety information contained in the manual
must be read and understood.
Warning:
Risk of danger
Warning:
Risk of electric shock
Warning:
Risk of high pressure
Warning:
Risk of burn
Warning:
Risk of fire
Warning:
Consult manual
Do not install or operate the EQ LTE™
product(s) (hereinafter can be referred to as
the device) until you and all personnel
concerned have read and established a
working understanding of the device inclusive
of duties to be performed while installing,
operating and maintaining the device.
This manual contains IMPORTANT SAFETY
DATA and should be printed and kept with the
device at all times.
Improper use of the device may compromise
the safety and protection of the device and its
environment.
Never use the device in explosive
environments.
Use only CATIII 600V or better insulated, test
leads and voltage probes as supplied with the
device.
Before use, verify current clamp, test leads
and voltage probes for damage or wear
indicators, dispose of and replace when
damaged or worn.
No serviceable parts inside, dispose according
to local regulations.
Wall adaptor is part of a SELV circuit, use only
supplied net adapter.
Don’t mix lead and voltage probe colors and
disconnect unused leads to prevent short
circuits.
Do not expose this device to heat, fire or direct
sunlight.
When installing, commissioning, operating or
carrying out service or maintenance on the
device, personnel must use relevant safe
working practice and observe all relevant local
health and safety requirements and
regulations.
Lethal voltages may be present at or around
the device. Electricity has the potential to
cause severe personal injury or death. Use
extreme caution when carrying out checks
where lethal voltages may exist.
Never remove or tamper with safety devices,
guards or insulation materials fitted to the
device or the compressed air installation.
Compressed air has the potential to cause
severe personal injury or death. Use extreme
caution when carrying out compressed air
related checks.
Hot and cold surfaces may be present at or
around the device. Use caution as necessary
A requirement of fault-free operation and
fulfilment of any right to claim under guarantee
is that documentation is observed.
This document is subject to change without
notice, if in doubt, do not proceed!
It is not possible to anticipate every
circumstance that might represent a potential
hazard. If the operator employs an operating
procedure, an item of equipment or a method
of working which is not specifically
recommended the user must ensure the
product will not be damaged or made unsafe
and that there is no risk to persons or property.
Failure to observe safety precautions or
implement safe working practices may be
considered dangerous practice or misuse of
the device.
Section 1.2: Installation
Installation work must only be carried out by a
competent person under qualified supervision
equipped with the correct tools and
appropriate protection against hazards.
When necessary, locate the emergency power
off before installing the device; never work
alone if potentially hazardous conditions exist.
Disconnect the power before connecting the
device, never assume power is off but always
