Section Iv - QCS00 & QCS1600
Filter Replacement
replace the filter when:
The water being discharged is too
cloudy.
The level indicator indicates that the
filter is clogged.
notiCe
Always observe the requirements of
the Water Resources Act and other
legal regulations pertaining to the use
and handling of filters.
Always keep a spare filter set on hand.
Only use original manufacturer filter sets in
order to ensure operational reliability and
warranty compliance.
remove the plastic bag before
installing the filter set.
Place the new filter set near the unit
and retain packaging for disposing of
the old filters.
Shut off condensate inlet.
Open the QCS lid.
Open the service valve and let the
liquid drain off to below the level of the
filter cartridge.
Slowly lift the old prefilter and main
filter out of the container, turn filters
counterclockwise 45° and place on the
top edge of the container to allow to
drain.
remove the handles and fit them onto
the new main filter.
Put the drained filter set into the plastic
bag and ensure correct disposal.
using the handles, insert the main
filter into the filter receptacle of the
container. When noticeable resistance
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
is felt, manually push the filter into
position and snap the handles into
place at the side of the filter receptacle.
Insert the prefilter above the main
filter and fit onto the guide pipe when
closing the housing lid.
Open condensate inlet.
Close the service valve.
45°
♦
♦
♦
24
Quincy Compressor-QCS High Efficiency Emulsion Separators
