QuickWorldWide Super Learner Pro, Instruction Manual

Page: 55 / 85

Page 55 of 85
5-4 TAIL INSTALLATION
No. Bag# Description Qt.
1 Step 4 Assembly up to step 4 1
2 Step 5-3 Tail Assembly 1
3 In box Boom Support 2
4 5 Boom Support End 4
5 HB M3x12 Cap Head Bolt 2
6 HB M3x8 Cap Head Bolt 2
7 HB M3 Locknut 2
8***** CA Glue 1
•
Note for installing the timing belt: Turn the Tail assembly so that the Tail Output Shaft
pointing upward put the belt onto the Transmission, then twist the Tail Assembly 90
o
to the right. Make sure the belt not too tight or loose. Tighten the four screws on the
boom holders.
•
Measure the Boom Support carefully before cutting. It is a good idea if you install one
end of the rod first, then make a measurement on the other and cut it. Remember
apply CA Glue for the rods when installing into the Support Ends.