25
Quicksilver 810 Arvor — System & Component Overview and Operation
continuously. Press the on/off switch again within 6 seconds . The system will confirm that it is ready
for use when the LED light remains green and the buzzer sounds twice.
To move the bow to the port direction, push the joystick to the left. To move the bow to the starboard
direction, push the joystick to the right. Refer to the thruster owner’s manual for complete details on
the operation and warranty information.
To turn off the bow thruster controls, press the on/off switch once.
If 2 control panels are installed at separate helms, never
operate the bow thruster from both panels simultaneously.
Refer to the bow thruster owner’s manual for exact battery
requirements
Bow Thruster
Battery switch
Charge relay
Control panel
Do NOT test the bow thruster while the boat is out of the
water, unless you are certain that everyone is a safe
distance from the thrust tube.
Never allow the bow thruster to run for longer than 5
seconds with the boat is out of the water.
Bow Thruster Movement
Summary of Contents for 810 Arvor
