Quicksilver 810 Arvor — System & Component Overview and Operation
12
removed and the tank completely dried before refilling the tank with any fuel. Check the fuel lines
frequently for leaks or any surface cracking on the hose. Replace the hose immediately if any issues
are found.
Storage
Long periods of storage and/or non-use, common to boats, create unique problems. When preparing
to store a boat for extended periods, of two months or more, it is best to completely remove all fuel
from the tank. If it is not possible to remove the fuel, maintaining a full tank of fuel with a fuel
stabilizer added to provide fuel stability and corrosion protection is recommended.
REFER TO THE ENGINE MANUFACTURER’S MANUAL IN YOUR OWNER’S MANUAL PACKAGE FOR
COMPLETE INSTRUCTIONS AND WARRANTY INFORMATION.
2. Fresh Water System
The fresh water system consists of an 80 liter water tank, pump, and plumbing connections for water
to the galley and the transom shower.
Filling the Tank
The water tank can be filled through the water fill inlet located on the port side deck trail next to the
deckhouse. Fill the tank only from a source known to provide safe, pure drinking water. Use only a
plastic hose to fill the water tank.
Fresh Water Pump
The fresh water pump delivers water from the tank to the galley faucet and transom shower. To
power the system turn on the WATER PUMP switch located at the helm. Turn off the power to the
pump when your boat is not in use or when the fresh water tank is empty.
Disinfect the Fresh Water System
The following is a recommended procedure to disinfect the fresh water system:
1. Flush the entire system thoroughly by allowing potable water to flow through it.
2. Drain the system completely.
3. Fill the entire system with an approved disinfecting solution. Check with your dealer for
recommended products, and follow the manufacturer’s instructions.
4. After disinfecting, drain the entire system.
5. Flush the entire system thoroughly several more times with potable water.
Maintenance
Maintenance of the fresh water system will require you to check the fittings and hoses to make sure
that there are no leaks. Before the winter season, the fresh water system must be completely drained
to avoid damage.
Do not obstruct or modify the ventilation system.
Be sure to fill the water tank from a source known to
provide safe, pure drinking water.
If you do not use the freshwater system for long periods of
time, or only use it seasonally, it is recommended that you
disinfect the system before using.
Summary of Contents for 810 Arvor
