Quicksilver 755PH — System & Component Overview and Operation
44
25. Motorwell Prep Station (optional)
Located over the motorwell, an optional prep station is available that contains a cutting board and
two rod holders. This prep station covers the motorwell, however, it does not interfere with the
normal operation and trimming of the engine. If you want to tilt the engine to trailer position, you
must rotate the prep station forward. Simply lift the prep station from the rear and it will rotate out
of the way.
Table base
Table leg
Table
Table storage
Table leg storage
Cockpit Table
Aft Center Cockpit Hatch
Motorwell Prep Station
Prep station in lowered position
Prep station in raised position
Before tilting the engine to trailer mode, make sure that the
prep station is rotated forward. Failure to do so could cause
damage to the engine and prep station.
Cutting board
Rod holder
Summary of Contents for 755PH
